wpginterceptor

oh yes I dont mess with sensors..  part # 05033307AC is the Dodge Sensor Part number..  was an ez swap!  drove it around all afternoon and no more stalling out.

oh yes I dont mess with sensors..  part # 05033307AC is the Dodge Sensor Part number..  was an ez swap!  drove it around all afternoon and no more stalling out.

caliper seizing up.. just order a new caliper and ceramic pads, install with 2 new front rotors and be done with it!

caliper seizing up.. just order a new caliper and ceramic pads, install with 2 new front rotors and be done with it!

caliper seizing up.. just order a new caliper and ceramic pads, install with 2 new front rotors and be done with it!

caliper seizing up.. just order a new caliper and ceramic pads, install with 2 new front rotors and be done with it!

start with tires and work your way to suspension.. try and figure if its front or back!

REMEMBER.. you cannot use any other washer fluid other than the blue stuff..  if you use the yellow stuff the washer fluid detection sensor cannot detect it and will show low washer fluid warning light on dash!! EVEN WHEN THE JUG IS FULL!!!
 

5 minutes smoking if its really bad.. otherwise first 5 seconds is valve seals also! ask a mech if you don't believe me.  you might get lucky and it will be the PCV.. I doubt it though.  Pull the pcv and shake it.. does it rattle.. YES then its working!
 
 

5 minutes smoking if its really bad.. otherwise first 5 seconds is valve seals also! ask a mech if you don't believe me.  you might get lucky and it will be the PCV.. I doubt it though.  Pull the pcv and shake it.. does it rattle.. YES then its working!
 
 

here is a video and he explains it at the 3 min mark
 
 

Valve seals! then change the plugs...  google it
 
otherwise when you shut the car off, the oil seeps thru the valve seals and goes in combustion chamber and will burn off when you start it again.. Wont hurt nothing other than youll have to add oil occasionally and also will have to change the spark plugs more frequently!!.. til you fix it! PS: run thicker oil,,,

use the keyfob and push the start button with the keyfob! DONT USE YOUR FINGER TO START CAR, USE THE KEYFOB AND USE THAT TO PUSH BUTTON!! does the car start?
 
LIKE THIS
 
 

pump was an ez change on the 2.4! also ran new fluid thru

replace the upper control arms and lower toe end links before doin an alignment!

ABS light and traction light on is usual a bad abs sensor!  mine said one on the rear was bad!  I jacked the car up took each one out (did all 4).. cleaned each sensor with glass cleaner and reinserted each one back into position... dropped back on whee;s.. and light went off before I even got all the way down the driveway! happened 2 years ago been off ever since!!!

ABS light and traction light on is usual a bad abs sensor!  mine said one on the rear was bad!  I jacked the car up took each one out (did all 4).. cleaned each sensor with glass cleaner and reinserted each one back into position... dropped back on whee;s.. and light went off before I even got all the way down the driveway! happened 2 years ago been off ever since!!!

ABS light and traction light on is usual a bad abs sensor!  mine said one on the rear was bad!  I jacked the car up took each one out (did all 4).. cleaned each sensor with glass cleaner and reinserted each one back into position... dropped back on whee;s.. and light went off before I even got all the way down the driveway! happened 2 years ago been off ever since!!!

back in the day.. me and a buddy shoehorned a 460 into a Hyundai pony!
needless too say once the Police pulled us over and they called in the vehicle inspection unit.. the car was pulled off the street as it was considered unsafe!
 
don't see what the problem is... the motor was practically right in the car sitting beside us as we drove