Jump to content

wpginterceptor

Journey Member
  • Posts

    62
  • Joined

  • Last visited

  • Days Won

    5

Everything posted by wpginterceptor

  1. today when i was braking, and the ABS comes on as very slippery out..the usual light flicker, but now my stereo occasionally the lights go out on it.. stereos plays etc, just the lights go out on it for a couple seconds, goes black, then comes back on and the stereo plays thru.. if you werent looking you wouldnt notice as the sound is continuous!
  2. for the 2.4L the brand would have its own number but for Fram its 10060 PS: a bigger filter doesnt mean it filters better!! pay for a quality filter and youll get best protection!! there are alot of youtuibe videos where they cut open filters and you see all the filtration inside.. WIX makes awesome filters
  3. Deadf spot in your starter.. had this issue on my 78 Chevy Nova!! was a dead spot in the starter.. new starter fixed that
  4. oh yes I dont mess with sensors.. part # 05033307AC is the Dodge Sensor Part number.. was an ez swap! drove it around all afternoon and no more stalling out.
  5. 2.4.. i found it, its on back side.. Ill change it tomoro
  6. ok so car was driving and stalled out. I came to a stock and it sarted right up, with check engine light!.. drove it home about 20 min drive, stalled a couple more times on way.. Once home I checkd for codes and it gives me a P0335 which is CRANKSHAFT POSITION SENSOR! these hard to get at on these cars? PS: car runs great til it stalls out, then sometimes wouldnt start would just crank.. wait a min or 2 and it starts right up runs great til it stalls again few mins later! but made it home
  7. im on my 3rd Alternator on this car now... 180 000 Kms
  8. Now that its slippery out, I notice when i hit the brakes on ice and my ABS comes on and pulses the brakes, i notice the electrical power flickers alot, Headlights flicker (noticeably) interior lights on dash flicker to the pulse of the ABS... Anybody else have same issue?? is Alternator goin on it???
  9. Just the Traction light is on?? or is the ABS and Traction light on?? the traction control works thru the ABS.. if you have a bad ABS sensor then both lights will be on!! this has happened to me, i pulled each sensor and cleaned them with windex, put them back and light when out after a short drive.. never came on again since then and that was 5 years ago now!!
  10. my sensor is fine since I went back to the Blue washer fluid
  11. Mine still does it, but I can push it hard enough to start it! then lets say i go shopping and come out from the shopping mall the pedal is soft and ez to start! its when i leave it overnight and the next morning the pedal is stiff and I have to push extra hard to start it!
  12. Anybody else have this problem?? the heat shield around the exhaust is startin to fall... Should I just rip it out or try and put it back??
  13. ARROWS POINT DOWN!!!!!!!!! and sometimes all it takes is a few taps on the ground to clean it out a bit
  14. im having this issue now.. its the wiring where the door meets the car! next time it happens, hold the door wide open and use the switch, then the windows will work... close the door and doesn't work again...
  15. im beginning to have wiring issues just like this! started in the tailgate hatchback thing and now starting to get it drivers side door.... windows wont go up or down UNLESS I hold open the door... just great
  16. caliper seizing up.. just order a new caliper and ceramic pads, install with 2 new front rotors and be done with it!
  17. oh I understand that JOHN, but when car sits overnight the brake pedal is hard, but after she starts and I drive to Walmart, go inside shop etc and 2 hours later come out the brake is soft.. but when I go to start it after overnight the brake is hard!
  18. im not.. as I said just kinda strange! wonderin if anybody else has that too..
  19. strange issue.. Did a complete brake job on wifes car, front and rear rotors and brake pads all around! now, when I go to start the car after sitting overnight, the brake pedal is fairly hard to push.. so when I go to start the car I notice I have to push it much harder than normal! when car starts and runs the pedal is soft (brakes work fine).. go to Walmart, shop for hourish go to start car and pedal is soft. NOW...leave car overnight again and and go to start it in morning and pedal is stiff and have to push noticeably push hard to start car. not a major issue but definitely noticeable!!
  20. mine took a while to start acting up.. went away though right after I put the glue stuff back in
  21. some cheap bearings don't last more than 5000 miles.. try turning the wheel side to side, does the sound go away and only heard when goin straight?/ if so bearings
×
×
  • Create New...