nerner

What was the depth of the speaker that you put in?

I hooked my power cable to the booster post, no problem. Been like that for about a year. If you look under the dash, there's a rubber grommet above the pedals. You can drill it or just slice it and just pull your cable through. I sliced it in a cross pattern just enough to pull the wire and still seals. Or you can just take the rubber grommet and replace it ith something if you don't like the idea of drilling/slicing.

Try partshub.ca

I wanted to post pics earlier but better late than never. here's pics of the Sony xav-64bt and the pioneer sub I installed.

I slid a block of wood under the carpet, about 1/2" thick then then I bolted the amp onto it.

I installed my amp under the driver seat without having to remove the seat. Just removed those lower trim pieces by the door sills to run my wires and insert them under the carpet.

I'm have an aftermarket sensor in one of my tires and it works just fine. Had to drive it a bit to relearn the new sensor.

I believe the challenger has a 5x115 bolt pattern. And the journey has 5x127.

bump Down for a meet in greater Vancouver area

Which side is it? Is it a 5 or 7 seater?

I just got my PAC wiring interface. Will try installing the Sony xav64bt over the weekend. Will try to snap pics while doing it.

Did you manage to get it installed. I'm going to try and install mine,just waiting for that PAC module I ordered.

the one for the avenger 3.5l v6 might work for the 09-10 journeys. engine bay kinda looks identical.

which set on ebay did you buy?

im using 235/55/19 yokohama yk580's on mine, don't see any reason why those snow tires won't fit.