Camper

Maybe it the chain, some time valve rods get that noise to. However I am suspected chain, it can be the pulley (plastic) get bad or chain get to loose. Listen in front of the engine, you can use a wooden stick to listen if the noise came from a chain chamber. Or you can get special tool to listen noise on the engine.That is my two sent.

Maybe it the chain, some time valve rods get that noise to. However I am suspected chain, it can be the pulley (plastic) get bad or chain get to loose. Listen in front of the engine, you can use a wooden stick to listen if the noise came from a chain chamber. Or you can get special tool to listen noise on the engine.That is my two sent.

LED bulbs for for way chipper, it only cost $35.00.

It could be air in the lines. Also it possible , that the o-ring in master cylinder whent bad and require dto be replaced.

Do you have a screen installed on the center console for rear passengers? If you do, then it probably to switch out put from front to the back.

You have to point them down in both options.

Depend, on how much you have to go down with adjustment. If I remember correctly, after retrofitting you do adjust headlight as well. So, both options required adjustment

It could be air in the lines. Also it possible , that the o-ring in master cylinder whent bad and require dto be replaced.

Exactly, I got your point, you dint need to say anything else. We all get your point, that the projectors you do install/mount in headlight is better (maybe/questionable).We all here have our choices to install or not to install LED bulbs or HID projectors. However I ask jkeaton, if he do have above parts with his LED light bulbs.

I have 2016 Crossroad, added as option trailer tow package. My dealer entered sales code and activated, without any issue. This was done in February-2016

I have 2016 Crossroad, added as option trailer tow package. My dealer entered sales code and activated, without any issue. This was done in February-2016

I do not have to slam my doors on mine 2016 Crossroad

I do not have to slam my doors on mine 2016 Crossroad

This error represent the following:
P0740 Torque Converter Clutch Circuit Malfunction

The engine and transmission are actually connected by a fluid coupling mechanism inside of the torque converter which is what multiplies the torque until the speeds equalize and create a "stall" speed where the difference in actual engine RPM and transmission input RPM is around 90% efficient. Torque converter clutch (TCC) solenoids commanded by the Powertrain control module/Engine control module (PCM/ECM) or the Transmission control module (TCM) to direct hydraulic fluid and engage the torque converter clutch to create a solid coupling and increase efficiency. The transmission control module has detected a fault with the circuit that operates the torque converter clutch solenoid.
Causes of this DTC may include: Wiring harness to transmission damaged, loose connection, open or shorted circuit Torque converter clutch (TCC) solenoid Transmission control module (TCM)

I do not have to slam my doors on mine 2016 Crossroad

Will those work on 2016 Crossroad?

Already done so, have to go to see dealer.

Thank you, will close this discussion.

Does any body use/install this kind of lights:
http://www.ebay.ca/itm/1Set-RH-LH-Red-Tail-Rear-Fog-Light-Assembly-For-Jeep-Compass-11-14-DODGE-JOURNEY-/321913186523?hash=item4af38568db:g:jgEAAOSw7hRWPGn-&vxp=mtr
If , yes, then what kind of the harness and light bulb socket you
use

This is the photos, that I am talking about, sorry about the photos is not clear, it hard to drive and take photos at the same time

I see it dome light with a cubby today on ebay

You cannot get text on display/screen when you driving, it only option available is listen. So it will be interrupting the radio, when you listen. However, if you do have connected lockpic, then you can read text message, without interrupting radio.

You cannot get text on display/screen when you driving, it only option available is listen. So it will be interrupting the radio, when you listen. However, if you do have connected lockpic, then you can read text message, without interrupting radio.

gues i have to go see dealer, for this issue

You can open same installer in internet explorer, it built in Windows 10 as well. On your EDGE click on top right corner(tree dots) a new menu will pop up, then you should see on that menu "Internet Explorer", it actual IE, not EDGE, then in IE you can open any page in "Compatibility Mode"; under settings.Hope this help