Limp mode

[Davidy]

Hello! After turning on the transmission goes into 3rd gear permanently I saw a p0760 fault Also p0733 So I purchased a solenoid pack But it didn't help There is good oil in the system however next question Does anyone have an idea?

[jkeaton]

P0760:

• Failed or failing Shift Solenoid: The most common cause which you already addressed
• Dirty or contaminated transmission fluid: Causes the solenoid to stick.
• Wiring/connector issues: Corroded or damaged wiring in the solenoid circuit.
• Valve body issues: Restricted hydraulic passages.
• Faulty Transmission Control Module (TCM)

P0733:

• Low Transmission Fluid: The most common cause, reducing hydraulic pressure.
• Dirty/Contaminated Fluid: Restricts flow and damages solenoids.
• Faulty Shift Solenoids: Specifically those responsible for 3rd gear.
• Internal Transmission Damage: Slipping clutches or broken bands (e.g., intermediate servo issues).
• Wiring/Sensor Issues: Damaged wiring or faulty speed

 

[5rebel9]

7 hours ago, Davidy said:

Hello! After turning on the transmission goes into 3rd gear permanently I saw a p0760 fault Also p0733 So I purchased a solenoid pack But it didn't help There is good oil in the system however next question Does anyone have an idea?

Good on oil, but what about the trans FILTER???

Is this a 4 speed or 6 speed trans? 

[John/Horace]

While the 62TE transmission does not require internal programming, you must perform a "Quick Learn" procedure and clear the adaptive memory in the vehicle's computer (PCM/TCM) after replacing the transmission, solenoid pack, or valve body. [1, 2, 3]