Jump to content

guls

Journey Member
  • Posts

    73
  • Joined

  • Last visited

Everything posted by guls

  1. guls

    rattles...

    Have rattle in passenger side door/ dash board on the same side. But that's about it.
  2. If you are talking about 8.4 system, it is only few hundred dollar option to buy the Nav version. I do not know if you can add it later. But a Garmin or TomTom is always an option.
  3. 6. Removing the back panel: Grab the back panel both sides at the bottom and pull it out. Disconnect the wiring
  4. Installation Steps: 1. First step is to find the Power source that is easiest to tap into. I wanted the LEDs to come on /off with the headlights at night and wanted them to dim with the dimmer switch. So easiest place was to tap into the headlight switch. 2. Remove the headlight switch, by turning it clockwise and pulling it out. See picture below. 3. The connector in the back- Black is ground and brown with Green stripe is Power. You can use any screw on the body as a ground. I just connected the positive wire here behind the switch to reduce the clutter. 4. For ease of access you have to remove the panel in next picture. 5. There are 2 bolts (I think 10mm) that you have to remove and then pins will pop out. There is a plastic screw/ clip, next to center console, I didn't mess with it I just let this hand down. Note: Don't worry airbag is at the bottom and you won't hurt it.
  5. Here are some pictures http://i952.photobucket.com/albums/ae10/ksport2/Journey/samsungpictures-1006_zps459081ce.jpg http://i952.photobucket.com/albums/ae10/ksport2/Journey/samsungpictures-1005_zps65d786fb.jpg http://i952.photobucket.com/albums/ae10/ksport2/Journey/samsungpictures-1004_zpsca8731da.jpg LEDs that I used are below, I used 4 LEDs (Blue Color) 1ea. in the front footwells, 1 in center console and 1 in the back side of center console for rear footwell areas. http://www.superbrightleds.com/moreinfo/led-wired-bolts/little-dot-smd-led-accent-light/639/
  6. Installed interior lighting in foot wells, center console, and in the back foot wells. Total cost less then $10. Pictures to follow.
  7. If its for phone, you can buy the mopar kit. If its for music streaming, then you mau have to swap the radio or maybe buy a module
  8. DarWrath, where did you hook them up to. Can you post some pictures.Thanks in advance
  9. guls

    Interior LED's

    I have all interior lights as LEDs. Only one's i changed are mirrors on sun visors and license plate and glove compartment. Over head lighting is already LED. The one in the trunks i can't find LED replacements. I used just regular LEDs.
  10. I have HIDs that i will be installing this weekend. You should try HIDs.
  11. guls

    newbie from Maine

    Missy welcome to the forum. You can download the manual from dodge website. Go to www.dodge.com Go under owners tab Go to 2nd option, owners and service manuals
  12. guls

    New Owner

    Welcome and enjoy
  13. There is a small envelope in top right hand corner, next to your forum screen name "Debra". Just click on it and it should show you the message.
  14. Debra, I will try a different dealer. No it is not suppose to leak by design. They need to inspect and see if there is something wrong with the seal or roof cut out is bad. Company has to fix this.
  15. guls

    New person

    Brett, welcome to the forum.
  16. Just psx24w in ebay and you will find the LED replacement. I don't know how bright they are though.
  17. I have a Samsung galaxy player 5.0 i can connect via bluetooth but not thru cable. When connected via cable it only charges
  18. Installed Philips crystal vision ultras in low beams.
  19. Don't know the build date. But the Journey was parked inside the showroom for many months. Only issue at delivery was warped rotors. Dealer replaced them and so far so good.
  20. Welcome, to the club. 8.4 without bluetooth......thats strange. But its ver expensive to swap the unit with OEM unit
×
×
  • Create New...