wpginterceptor
-
Posts
62 -
Joined
-
Last visited
-
Days Won
5
Content Type
Profiles
Forums
Gallery
Posts posted by wpginterceptor
-
-
today when i was braking, and the ABS comes on as very slippery out..the usual light flicker, but now my stereo occasionally the lights go out on it.. stereos plays etc, just the lights go out on it for a couple seconds, goes black, then comes back on and the stereo plays thru.. if you werent looking you wouldnt notice as the sound is continuous!
-
for the 2.4L the brand would have its own number but for Fram its 10060
PS: a bigger filter doesnt mean it filters better!! pay for a quality filter and youll get best protection!! there are alot of youtuibe videos where they cut open filters and you see all the filtration inside.. WIX makes awesome filters
-
could be a faulty Sensor
-
Deadf spot in your starter.. had this issue on my 78 Chevy Nova!! was a dead spot in the starter.. new starter fixed that
-
-
2.4.. i found it, its on back side.. Ill change it tomoro
-
ok so car was driving and stalled out. I came to a stock and it sarted right up, with check engine light!.. drove it home about 20 min drive, stalled a couple more times on way..
Once home I checkd for codes and it gives me a P0335 which is CRANKSHAFT POSITION SENSOR!
these hard to get at on these cars?
PS: car runs great til it stalls out, then sometimes wouldnt start would just crank.. wait a min or 2 and it starts right up runs great til it stalls again few mins later! but made it home
-
im on my 3rd Alternator on this car now... 180 000 Kms
-
once car is running it would be Alternator issue
-
Now that its slippery out, I notice when i hit the brakes on ice and my ABS comes on and pulses the brakes, i notice the electrical power flickers alot, Headlights flicker (noticeably) interior lights on dash flicker to the pulse of the ABS... Anybody else have same issue?? is Alternator goin on it???
-
Just the Traction light is on?? or is the ABS and Traction light on?? the traction control works thru the ABS.. if you have a bad ABS sensor then both lights will be on!! this has happened to me, i pulled each sensor and cleaned them with windex, put them back and light when out after a short drive.. never came on again since then and that was 5 years ago now!!
-
my sensor is fine since I went back to the Blue washer fluid
-
Mine still does it, but I can push it hard enough to start it! then lets say i go shopping and come out from the shopping mall the pedal is soft and ez to start! its when i leave it overnight and the next morning the pedal is stiff and I have to push extra hard to start it!
-
-
ARROWS POINT DOWN!!!!!!!!! and sometimes all it takes is a few taps on the ground to clean it out a bit
-
im having this issue now.. its the wiring where the door meets the car! next time it happens, hold the door wide open and use the switch, then the windows will work... close the door and doesn't work again...
-
im beginning to have wiring issues just like this! started in the tailgate hatchback thing and now starting to get it drivers side door.... windows wont go up or down UNLESS I hold open the door... just great
-
-
caliper seizing up.. just order a new caliper and ceramic pads, install with 2 new front rotors and be done with it!
- 2late4u, OhareFred, Summer Solstice and 1 other
- 4
-
-
im not.. as I said just kinda strange! wonderin if anybody else has that too..
-
strange issue..
Did a complete brake job on wifes car, front and rear rotors and brake pads all around!
now, when I go to start the car after sitting overnight, the brake pedal is fairly hard to push.. so when I go to start the car I notice I have to push it much harder than normal!
when car starts and runs the pedal is soft (brakes work fine).. go to Walmart, shop for hourish go to start car and pedal is soft.
NOW...leave car overnight again and and go to start it in morning and pedal is stiff and have to push noticeably push hard to start car.
not a major issue but definitely noticeable!!
-
On 2020-05-22 at 5:36 AM, probak118 said:
Its been four days now since I added 4 oz of rain-X to my washer fluid reservoir.( rain-x website instructions for adding to washer fluid)...no low fluid level alarm yet ? If my windshield beads water better may just keep doing this, unless my low level light suddenly starts coming on .
mine took a while to start acting up.. went away though right after I put the glue stuff back in
-
Lights and power flickers
in Electrical, Battery & Charging
Posted
i will try it thanx