Camper
-
Posts
189 -
Joined
-
Last visited
-
Days Won
2
Content Type
Profiles
Forums
Gallery
Posts posted by Camper
-
-
Can you please post a photo at night with working LED bar> Thx
-
Agreed,
-
Here is the actual link for Mopar hitch: http://moparonlineparts.com/dodge-journey-hitch-receiver-p-2441.html
Also I attached instruction for how to install the hitch.
Thx
-
Can you please provide exact link for your LED bar?
Thx
-
-
My dealer installed Mopar trailer hitch on my 2016 Croassroad with out any issue.
-
Take it easy. Good luck.
-
buckshot7526, can you please provide light output from your car, with your headlight? I wold like to see output at night, how far you can see with low beam and high beam.
Thank you,
-
My LED do not contain ballast, it direct plug and play. I tried to switching the wires at the plug still same issue.No idea what to do. Will keep original bulbs for now.
-
Returning home from long trip and on last Sunday, got ""check engine light"" on my 2016 Journey (22000 km), connected the scanner and get the following error:"""P084b-Transmission Fluid Pressure Sensor/Switch H Circuit Range/Performance"", Transmission stuck in one gear and do not changed it went to "limp" mode, however it goes to reverse as well.. So I can go 60 km/h on 4000rpm. Dropped car to dealer and get "Valve Body" replaced, everything done under warranty.
On my previous Journey-2012 (161000 km) never have this problem.
-
Old ,regular light bulbs, do not causing any error, only LED
-
No matter what I try, I get those errors. Just replaced all headlights bulbs with LED, on my 2016 crossroad, hi beam and DRL working without any issue, as fog lights as well. However, low beam is different story. The lights, is turned on, so , when I switch gear to revers or drive position then right side low beam light turned off, when I put gear in the parking position and shout vehicle off light came back. I tried 4 different LED light bulb. However passenger light working without any issue.
-
-
That is correct, I just swap them for testing. I think the issue with the "driver", I will try to swap the "drivers" from hi beam to the low beam and will see if it working that way.
-
Same light bulb, working on high beam, without any issue (:
-
Even with resistor, left side low beam goes off after 15 min off ride.Just removed both resistors from both sides. Maybe some one can point to solution.
-
Just replaced all headlights bulbs with LED ,on my 2016 crossroad, hi beam and DRL working without any issue, as fog lights as well. However, low beam is different story. The lights, is turned on, then right side light turned off, 10-15 min, later left side turned off. Added resistor to both sides, right side do not light up at all, after that, but left side still working fine. This is what I installed for low beam:Atshark 80W 7200LM 9006 LED Headlight / Headlamp Conversion Kit 3 COB LED 6000K Cool White Super Bright- Replaces Halogen & HID-2 Pack
Any idea, what it can cause this? Any one run on this problem?
-
-
-
-
Check the lugs on both front tires, maybe you get some loose.
- Journey_SeXT and dhh3
- 2
-
Not only quality issue, they played the same songs over and over for month and charge for that
-
I have Samsung, and it working fine, same vehicle.
-
""You bought a base model and got he 2.4, but if I recall correctly the 3.6 was standard in everything else."""
You can choose different engine on SXT model as well
Limited engine power on jumpstart
in Electrical, Battery & Charging
Posted
I do have same problem before, here it is from my one of the post:"""""
Returning home from long trip and on last Sunday, got ""check engine light"" on my 2016 Journey (22000 km), connected the scanner and get the following error:"""P084b-Transmission Fluid Pressure Sensor/Switch H Circuit Range/Performance"", Transmission stuck in one gear and do not changed it went to "limp" mode, however it goes to reverse as well.. So I can go 60 km/h on 4000rpm. Dropped car to dealer and get "Valve Body" replaced, everything done under warranty.
On my previous Journey-2012 (161000 km) never have this problem.""""". Hope this help