mr_chief Posted February 11, 2013 Report Share Posted February 11, 2013 Hello, I have a problem with park assist - it`s stop working. Backup camera is still working but no sound when I move to object. In settings sound is on. It`s possible to reset park assist? Anyone have similar problem? / Best regards, Quote Link to comment Share on other sites More sharing options...
JOEK Posted May 4, 2013 Report Share Posted May 4, 2013 I lost all audio - including the park assist audio warnings - on my 2011 DJ Lux. The warranty center did not know what the problem was, but they disconnected the negative battery cable, waited a few minutes, and re-connected it. All my audio was back. Quote Link to comment Share on other sites More sharing options...
bigtsr Posted May 4, 2013 Report Share Posted May 4, 2013 What you accomplish by disconnecting the battery is a RESET of the TIPM (totally Integrated Power Module) this can resolve many of quirky problems that pop up from time to time. Bless the almighty computer!!!!!!! Quote Link to comment Share on other sites More sharing options...
Official Dodge Support DodgeCares Posted May 6, 2013 Official Dodge Support Report Share Posted May 6, 2013 There was a TSB released on this issue. Copy below. NUMBER: 08-031-11GROUP: Electrical SUBJECT:Flash: Park AssistOVERVIEW:This bulletin involves selectively erasing and reprogramming the Park Assist ControlModule (PTS) with new software.MODELS:2011 (JC) Journey (International Only)NOTE: This bulletin applies to vehicles equipped with a manual transmission andParksense Rear Park Assist System (sales code XAA) built before March 18,2011 (MDH0318XX). Quote Link to comment Share on other sites More sharing options...
Romirez Posted May 3, 2023 Report Share Posted May 3, 2023 Hi, my rear parking sensors don't work, there were 2 faulty ones, so I replaced all four but still the park assist service light is still on, my local garage run a diagnostic but still no joy. Does anybody know where the park assist control module is located, I would like to find it and get the part number and order another one. I do have a 2011 Fiat Freemont. Quote Link to comment Share on other sites More sharing options...
Tobben Posted July 10, 2023 Report Share Posted July 10, 2023 On 3.5.2023 at 1:56 PM, Romirez said: Hi, my rear parking sensors don't work, there were 2 faulty ones, so I replaced all four but still the park assist service light is still on, my local garage run a diagnostic but still no joy. Does anybody know where the park assist control module is located, I would like to find it and get the part number and order another one. I do have a 2011 Fiat Freemont. Hi Romirez! Did You figure out where the Park Assist Module is located? Quote Link to comment Share on other sites More sharing options...
Leeroy Posted October 18, 2023 Report Share Posted October 18, 2023 Dodge says this module is in the left side rear interior plastic panel , beside 3rd row seat, Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.