eiffelpower

Good Afternoon, 

I have a 2013 SE 2.4, 155xxx miles , and in the past it would go into limp mode or completely stall on the highway, when it did, it would store a DTC and it would always be the cam position sensor, I have replaced it a few times with OE sensors and it would then fire up and run fine for a month or so then do it again, this last time it started to misfire then stalled completely, I was able to re-start the car and limp it home, once I got it home the car seems to run fine at idle, but no check engine light and no stored codes, outside of normal maintenance I have replaced the throttle body and intake manifold gaskets, the scan tool I'm using also allows me to perform the cam sensor re-learn but that didn't seem to make any difference, I've done several searches and have found people having similar issues but never a resolution, any help on the next step would be much appreciated. 

Scan tool I'm using is an Encore OTC. 

Sweetness the reset worked now its all good . thanks for the advice

I haven't tried the battery reset yet . Its only on the left side . I did swap bulbs as well both will work fine on the right side . I will try the reset and see if it works . does the 2013 DJ's have the tipm as well I was reading some people have problems with those?

So I installed hid kit but made the mistake of not reviewing problems other people had so the would turn on then blink twice and turn off . so now I'm just going to do a projector retrofit instead but for the meantime I was going to put my halogens back in . got them both in and now my left headlamp won't work . the bulb is fine put it to 12v to it and it lights up even bought a new one and still same issue. So I put my voltmeter on to the plug and its getting 12v so I'm stupmed....any help would be appreciated

Wheels I used vht wheel paint then cleared with vht as well

On the lower fascia it had five or six push pin retainers and then pops out

I'm gonna put halos in the fogs and I thought about running led strips at the bottom of the headlight housing on the inside when I take them apart.. it's my wife's as well haha I still do what I want with it though .Then figure out if any possible way to put them in headlights . There isn't

Much of a contour shape on the stock headlights . The calipers are probably gonna be cleaned a lot haha. . I painted everything . The lower

Fascia does separate nicely from the plastics . I use regular acrylic enamel gloss black with self etching primer .

Thanks . Appreciate it

Finally got around to paint everything.debadges the rear as well looks so much cleaner . Loving the white calipers and lug nuts .

Now gonna take apart headlights paint inside black then add some halos

Some pics from how it started to now