Jump to content

wvt

Journey Member
  • Posts

    2
  • Joined

  • Last visited

About wvt

Profile Information

  • Region
    Canada Prairie Provinces
  1. Found this info in a note about Dodge TPMS systems, looks like I need to find out what scan tool allows manual entry. Also found the info about the transponders in 3 wheel wells: http://www.moderntiredealer.com/channel/retailing/article/story/2014/07/tpms-setups-on-dodge-chargers.aspx
  2. At my friends shop, we installed new winter tires on 17" steel wheels (verified proper offset/fitment etc.). I ordered 4 new TPMS sensors from ebay to use, p/n: 56029398AB. Now all information indicates the TPMS system should autolearn the new sensors and positions. It's been over 400km, speeds over 120km/hour, and still no luck. Only the Front Drivers sensor displays a pressure on the instrument cluster, the others trigger a service code with no reading. At his shop they have proper scan tools and TPMS tools, we tested from the sidewall of each tire using a TPMS scanner. They all report properly and at the the correct frequency for a 2014. We've increased to 40PSI, driven another 70km and still no luck. Is there a dealear procedure to manually program the IDs via OBD-II or to issue a manual relearn procedure and either upload the IDs via OBD-II or issue a learn with the TPMS tool similar to GMs? We connected a Snap-on SOLUS ultra and cleared the TPMS codes, but did not see anything that offered a manual relearn. Has anyone with 17" steel wheels and TPMS every had an issue with the auto learn on their journey? I was almost considering a strip of foil duct tape on each side wall over where the TPMS sensor is to try and direct the signal so the wheel well sensors pick them up maybe. But haven't tried that yet. We assume the front drivers tire relearned as it may be the wheel well without a pickup sensor for learning. (3 wells have pickup sensor, 4th tire is assumed)
×
×
  • Create New...