Camper
-
Posts
189 -
Joined
-
Last visited
-
Days Won
2
Content Type
Profiles
Forums
Gallery
Status Updates posted by Camper
-
Hi Kathleen,
Can you please confirm, that the Dodge changed the warning signal and lights for oil change from 10.000 km to 16.000 km? My 2016 Journey Crossroad do not provide the this warnings, even i draw 2000 km over oil limit (full synthetic oil) at 12000 km I do not receiving any warning to change the oil.Please confirm.
Thank you,
Alex
-
can you please provide light output from your car, with your headlight? I wold like to see output at night, how far you can see with low beam and high beam.
Thank you,
-
Hello,
Can you please help me to find the correct answer for the following error:
Can you please (if possible) find out from engineers, if it possible replace regular head light bulbs with LED light bulbs.
Also can you, please (if possible again) to find from engineers, what this following errors mean, and how to be fixed:
1) B162E-11 RIGHT LOW BEAM CONTROL-CIRCUIT SHORT TO GROUND
2) B162E-15 RIGHT LOW BEAM CONTROL-CIRCUIT SHORT TO BATTERY OR OPEN
3) B162A-11 LEFT LOW BEAM CONTROL CIRCUIT SHORT TO GROUNDhere is my VIN:3C4PDCGG2GT191893
Here is more information, just in case:
""No matter what I try, I get those errors with LED.I tried 4 different LED light bulbs. Just replaced all headlights bulbs with LED for testing, on my 2016 crossroad, hi beam and DRL working without any issue, as fog lights as well. However, low beam is different story. The lights, is turned on, so , when I switch gear to revers or drive position then right side low beam light turned off, when I put gear in the parking position and shout vehicle off light came back. I tried 4 different LED light bulb. However driverside light working without any issue.
Also, regular light bulbs working fine, no errors and no shout down, after switching the gear
"""Thanks in advance,
Alex- Show previous comments 1 more
-
I tried two different sets,even tried mix them, still same problem.What LED bulb do you use on your Journey?Can you please provide a link for it, so I can buy them as well?
Thank you,
Alex
-
to be honest i dont think the led is the best option i kind of wish i had went with the hir bulb that has been discussed on this blog, i mean the led lights are okay but not that much better than i thought they would be. i used off amazon yita motor they do make the signs and road markings a lot brighter but i dont think i see that much farther down the rd.
-
As far as I know, the vehicle will set fault codes for LED lights because it's not configured to accept them. LED or HID lights are not optional on a Journey, so the resistance values are likely setting these codes.
Engineering will not assist in solving issues with aftermarket parts - sorry!