Bryan

no chain noise its a pretty quiet engine.

i did the hard reset last night.disconnected the neg pos terminals zip tied them together oven night. hooked it back up today still has the same problem.wondering if it could be a computer problem.

it has 155000 on it.iv had it for two years and no major problems replaced the starter and air filter, flushed the coolant system. it through this crankshaft fault over the summer.replaced the sensor and that fixed the problem. it through the same code last week. so i replaced the sensor with a duralast sensor. it still through the same code.so i picked up a second sensor vvt the second time still didn't fix it pulled the codes again and its crankshaft sensor unlearned variation. and a random misfire code. oil changes every 5 thousand.

2.4

it a 2.4. it was only driven about 10 miles with the light flashing. just long enough to get it home. i just did a hard reset on the computer last night.and changed the plugs.it still not running right.

hello i have a 2010 journey that out of the blue through a crank sensor code and started misfiring.changed the crank sensor twice and put new plugs in. but it still wont run right.did a hard reset on the computer last night but it still through a code crank unlearned variation.it wont stay running on all cylinders to do a relearn cycle. im at a loss could it possibly be the computer.

hello, i have a 2010 journey with 160000 mi. the other day i was driving and it stared to misfire and the check engine light started to flash.went to the part store and had the code pulled and it was the crank sensor code and a misfire code. changed the sensor and gave it a test drive and it was still doing the same thing. put another sensor in and changed the spark plugs. test driven again and still not running right.idles ok start to drive in a couple hundred feet it starts to misfire when you turn the car off and restart it run ok for a couple 100 ft then the same thing happens, any thoughts im at a loss